/*
ReadAnalogVoltage
Reads an analog input on pin 0, converts it to voltage, and prints the result to the Serial Monitor.
Graphical representation is available using Serial Plotter (Tools > Serial Plotter menu).
Attach the center pin of a potentiometer to pin A0, and the outside pins to +5V and ground.
This example code is in the public domain.
http://www.arduino.cc/en/Tutorial/ReadAnalogVoltage
*/
// the setup routine runs once when you press reset:
void setup() {
// initialize serial communication at 9600 bits per second:
Serial.begin(9600);
pinMode(A0,OUTPUT);
}
// the loop routine runs over and over again forever:
void loop() {
// read the input on analog pin 0:
int sensorValue = analogRead(A0);
// Convert the analog reading (which goes from 0 - 1023) to a voltage (0 - 5V):
float voltage = sensorValue * (5.0 / 1023.0);
// print out the value you read:
Serial.println(voltage);
}
Đăng ký:
Đăng Nhận xét (Atom)
Bài G - Educatioal Round 62
Đề bài: Bạn được cho 1 đồ thị vô hướng đặc biệt. Nó bao gồm $2n$ đỉnh được đánh số từ 1 đến 2n. Dưới đây là một số đặc tính của đồ thị: + ...
-
Hamiltonian Path is a path in a directed or undirected graph that visits each vertex exactly once. The problem to check whether a graph (di...
-
An array is a sequential collection of elements of same data type and stores data elements in a continuous memory location. The elements of...
-
A multi-dimensional array is an array of arrays. 2-dimensional arrays are the most commonly used. They are used to store data in a tabula...
Không có nhận xét nào:
Đăng nhận xét